Upozornenie!
Vitajte na našej novej stránke! Treba sa znova registrovať .
1,50 palcový OLED display Module 128x128
1,50 palcový OLED display Module 128x128
1,50 palcový OLED display Module 128x128
1,50 palcový OLED display Module 128x128
1.5inch OLED Display Module, 128x128 Pixels, 16 Gray Scale, SPI/I2C Interface
Overview
This is a general OLED display Module, 1.5inch diagonal, 128x128 pixels, 16 gray scale, with embedded controller, communicating via SPI or I2C interface.
Features
- 128x128 high resolution
- 16 gray scale, better display effect
- Supports SPI or I2C interface, configured via onboard resistor
- Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32)
Specifications
- Driver: 1327
- Interface: SPI / I2C
- Display color: White
- Gray scale: 16
- Resolution: 128x128 (most other competitive products are typically 128x64)
- Viewing angle: >160°
- Operating voltage: 3.3V / 5V
- Dimension: 44.5 x 37 (mm)
Interface
| SYMBOL | DESCRIPTION |
|---|---|
| VCC | Power (3.3~5V input) |
| GND | Ground |
| DIN | Data input |
| CLK | Clock data input |
| CS | Chip selection, low active |
| DC | Data/Command selection (high for data, low for command) |
| RST | Reset, low active |
There are two available drive interfaces for this OLED module: 4-wire SPI and I2C:
| BS1 | BS2 | CS | DC | DIN | CLK | |
|---|---|---|---|---|---|---|
| 4-wire SPI | 0 | 0 | Chip select | Data/Command | MOSI | SCK |
| I2C | 1 | 1 | NC | I2C address selection | SDA | SCL |
Dimensions
Development Resources
Wiki : www.waveshare.com/wiki/1.5inch_OLED_Module
Weight: 0.02 kg
- 1.5inch OLED Module x1
- PH2.0 7Pin x1
Dodatočné parametre
| Kategória: | 1 - 2 palcové displeje |
|---|---|
| Záruka: | 2 roky |
Buďte prvý, kto napíše príspevok k tejto položke.
Pridať komentár